- Construction
- heat exchanger
- Group head
- Faema E61
- Temperature control
- no
- Preinfusion
- mechanical
- Flow control
- optional
- Boiler volume
- 1.8 l
- Boiler material
- copper
- Water connection
- water tank, plumbed water connection
- Steam power
- normal
- Extraction
- manual
- Pump type
- rotary pump
- Cup warmer
- yes
- Standby
- no
- Portafilter diameter
- 58 mm
- Heat-up time
- 15-20 min
- Control
- without app control
- Power
- 1500 W
The E61 was introduced in 1961 and has remained the reference point since. A thermosiphon keeps it at temperature continuously, instead of you having to search for it before each shot. You can get seals, shower screens and portafilters for it from specialty dealers, not just the manufacturer.
Before full pressure the coffee grounds are pre-wetted with low pressure. This is done mechanically through the design of the brew group, without electronics and without adjustments. It prevents channeling in the puck, that is spots where the water breaks through too quickly.
With Flow Control you manually control how quickly the water runs through the coffee grounds: start slowly, then increase pressure. That takes the edge off acidic beans and gives you an extra adjustment. Without Flow Control the extraction runs at a fixed pressure, and that is enough for most recipes.
Copper conducts heat quickly and evenly, which is why it is the classic boiler material. It reacts more sensitively to hard water than stainless steel; a water filter or soft water significantly extends the time between descalings.
The machine can be permanently connected to the water line but does not have to be. When plumbed in you do not need to refill, but the location is fixed and an installer is required. A water filter in the line is then mandatory, not optional.
A rotary pump runs significantly quieter and more evenly than a vibration pump and holds the pressure more steady over the entire extraction. It is also the prerequisite for a machine to be connected to the water line.
The top surface of the machine is warmed by residual heat. A prewarmed cup draws less heat from the espresso, and those last degrees decide whether it still tastes the same in the glass as in the cup.
The machine switches itself off after a set time or goes into a low-power state. That saves electricity when you turn it on in the morning and then forget about it during the day. Without standby it stays on until you switch it off.
58 millimeters is the most common size. Baskets, tampers, levelers and distributors are available for it from many manufacturers, so you are not tied to an unusual size or a single supplier.
